Next put on the RJ-45 boot and OBD2 connector cable protector. I use 510 ohm, 1/4 watt resistors, but other people have used 560 ohm, 1/4 watt resistors andbeen perfectly fine. Newest BMW E-sys 3.33.0 3.32.1 Free DownloadĪnd if you don’t get a BMW ENET Cable with BMW E-sys software tested right now,buy it here:įirst I test the resistor to make sure it doesn’t fluctuate all over the place. The only thing missing from the picture is the OBD2 connector.īMW E-sys Coding software download check here: I’m using a simple and cheap multimeter to show that you don’t need anything special to test your cable. The only specialty tool is the network cable crimper. These are the tools I use to make my cables. This is a guide for BMW coding enthusiast DIYers to build a BMW ENET cable by themself.And you need to install BMW E-sys and connect this BMW ENET cable to your BMW,then run the software to perform BMW coding.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |